Panel Printers

D216 Panel Mount Printer with Rewind

Introduction

The D216 range of panel mount printers consist of either a 24 column (M180) or 42 column (M183) mechanism, rewind, paper low detector, paper roll holder and feed button housed in a metal enclosure, with an interface mounted on the rear.

The D216 panel printer fits into a 19" rack 3U high and takes up a panel space of 21E wide or alternatively can be panel mounted.

Connection to a serial or parallel source is extremely easy.

A single 5VDC supply is required. The D167 power supply can be used if only mains supply is available.

The paper exits the top of the D216 panel printer. Approximately 55mm of paper (20 lines of information) is displayed before the paper re-enters the bottom of the module, onto the rewind.

Paper and ribbon cassette changing are simple as the front panel hinges down to allow easy access.